Slow Install & Boot

From what I can gather from the Chinese forum is the hard drive needs to be on channel 0 of the SATA bus in the first position. I've checked my config and the CDRom is first on channel 0 (\Device\Ide\PciIde0Channel0) and the HD is second (\Device\Ide\PciIde1Channel0). Problem is you can't easily disconnect the CDRom in an old macbook so I can't test my theory.

DuMbGuM can you now try upgrading to 7057 and see if it still works properly.

Originally Posted by iaTa

DuMbGuM can you now try upgrading to 7057 and see if it still works properly.

I already upgraded from 7000 to 7057 and It was the exact same as a fresh install of 7057.

I think I'll just leave it alone now until RC1 is leaked or a fix arrives for 7057.

Oh really? I had hoped that it would still work properly by upgrading. Hmmmm, I wonder what's causing this. Lots of people experiencing the same issue by the looks of it. Let's hope that it's fixed in the next build.

Yeah its dissapointing

But hey, RC1 will be leaked probably just over two weeks from now, and apparently they actually finish a new build every working day so It should get fixed by then ! *crosses fingers*

Can confirm that 7048 works perfectly here too.

In my case, I just have one (1) sata connector on the motherboard, so I'm not able to move it. God damn this irritates me.
My comp is an acer aspire L5100. Wich is a small form factor desktop computer.
I bought it to give me a silent livingroom. It only gives me headaches at the moment. Hopefully there will be a fix for it.

The solution doesn´t help for 7057 on a eee pc with sata ssd as you can´t move it to another channel. Maybe somebody can find out which files from 7048 could be copied to 7057 to get it work. (I don´t care about the slow install, but it also boots up extrememly slow)

Originally Posted by Tharon

In my case, I just have one (1) sata connector on the motherboard, so I'm not able to move it. God damn this irritates me.
My comp is an acer aspire L5100. Wich is a small form factor desktop computer.
I bought it to give me a silent livingroom. It only gives me headaches at the moment. Hopefully there will be a fix for it.

ohhhhhhh...

ACER ASPIRE L5100 seems using amd chipset, it seems the solution doesn'twork well on chipset not intel. hi, i suggest you go to the bios and see if the harddisk is master or not,if it is slave,try to make it master

or see the hd info in bios---master\slave, works under which state, sata compatible or sata enhanced or ahci,then try to figure it out

To all that have this problem on PC, change your SATA HDD to SATA2_0 port and it will work like charm. Cheers

Well. as i said earlier, i do only have one sata-connector on my motherboard.
So I will not be able to change.
I'll wait untill the njext build arrives. Most likely in a week or two.